Estimate for you Pump System
After your well is drilled, we will give you an estimate for your pump system,
designed specifically for your well based on well depth, gallons per minute (gpm)
& static level. At this point contact Walter to discuss your exact
needs & requirements for the pump system. When you are ready to have the
pump installed, and after you have your electrical power in service, call to
schedule the installation. Should you ever need pump service, we run two
service trucks to provide you with excellent and prompt service, to handle any
repairs needed.
(Click on Picture to View as
Another Larger Image)
ANIMATED WELL AT
WORK
CLICK HERE
Pump Installation
"The modern
way to complete a well"
Virdell Drilling has used the pitless adapter method of pump installation since
the late 1960's in over 8,000 wells. In this type installation, the
pitless casing fitting is attached to the well casing around a hole cut in the
casing below the frostline to provide for a delivery pipe. The pump,
suspended from the drop pipe fitting, is lowered into the well. The drop
pipe fitting locks into the casing fitting, providing both a support for drop
pipe and pump within the well and a fluid tight conduit between the drop pipe
and the discharge pipe.
(Click on Picture to View as
Another Larger Image)
Features of the Pitless Adapter:
Frostproof
No
heating is required. All water conduits are buried below the frostline.
Pump is Easily Set
Pump
is simply lowered into the well and then suspended from drop pipe.
Pump is Easily Pulled
Drop
pipe is first supported with hoist. Then control cable is pulled manually to
free pump.
Low Cost
Costly well house construction is eliminated by using a
pitless adapter.
Here are a few pictorial
examples of our installations:
|
